Sump pump technology is nothing complicated. It basically collects floodwater and pumps it farther outside, where it can safely rain down on the floor.
A sump pump works very easily, but installing it makes a huge difference. Read on to learn about steps to do a sump pump installation below.
6 Steps To Do A Sump Pump Installation
To do a sump pump installation properly, you should take these steps.
1. Choose a site and set up your site
Find the lowest place in the basement. Areas that usually realize the accumulation of moisture first Now you’re digging a hole wide and deep enough to accommodate the submersible pump (the top should ultimately be flush with the ground).
Of course, digging a hole is not easy if the basement is concrete. You will need to use a slit hammer or jack hammer to break the concrete. After penetrating the masonry, continue drilling until the bore is wide enough for the pump sump.
2. Avoid potential blockages and place the drain pump in the hole
The most effective drain pumps are usually equipped with holes to let water in from the sides and bottom. If you don’t find the holes, you can drill them yourself over time.
Then, you can wrap a layer of filter cloth around the outside of the tank to keep silt and sludge from clogging the tank.
Add 2 to 3 inches of gravel to the bottom of the hole you made, and place a stone or field stone on top of the gravel to create a stable platform.
Insert a drainage pump into the hole and backfill the perimeter with drilled soil. At this time, even if you lightly press the body, it will not vibrate.
3. Test the float valve on the submersible pump
For a sump pump to work, the float valve must move freely up and down. When the water level rises, the float also rises, and when it rises, the pump operates. It is important to test the float valve before moving forward.
4. Run a hose or tube from outside the house to the valve
Equally important are check valves. This will direct the water away from the sink (not backflow). Draw an extension of a flexible drain hose or PVC pipe between the valve and the exterior surface of the house (use a glued joint and an elbow as needed).
Where the output hits the basement wall, drill a hole large enough to pass a hose or pipe through. To do this, use a drill or driver equipped with a hole saw bit. After passing the pipe through the hole, caulk around it to fill the large and small gaps.
5. Test the drain pump and make sure there are no leaks
Connect and steer the pump. Add water almost to the top of the sink. The float rises, the pump works, and the water is discharged. Make sure there are no leaks at the connections, and if all is well, put a cover on the sink.
6. Cover the area around the pump with concrete
Finally, you can finish your sump pump installation by plugging the hole around the pump. This is usually related to concrete.
Mix a small amount of concrete mix with peanut butter until smooth, spread it, and hide everything except the drain pump cover.